  |
|
1440
El Paso Blvd | Denver, CO 80221
303.279.7234
Open 7 - 5 Monday
through Thursday, 7 - 4 Friday |
|
Maintenance Hints
Lubrication Points:
Rollers at ball bearing where the shaft meets the roller. If the door is equipped with a torsions shaft, the bearing is located at each end and one in the center. If the door is equipped with extension or stretch springs, all pulleys should be lubed. Also, all end and center hinges where pivoting occurs should be lubed. DO NOT LUBE OR GREASE TRACKS
Recommended Lube:
Avoid:
Solvent or Detergent based lubricant like WD-40 How to
Lubricate a Screw-Drive Rail
First, diconnect the operator by pulling down on the release cord. Press your remote button once. The operator will start rotating the screw. Use a lithium based lubricant; we recommend and sell Lubriplate Aero for $5. Squeeze out a few beads along the rail, about a foot apart. Press the button on your remote one more time to stop the operator, and re-engage the release. Run your door, up and down, 3-5 times. |
|
|